Daily maintenance method of soft ice cream machine

2020-06-17 18:36:49 8


江门市澳好利机械制造有限公司


Cooling cylinder cleaning:


In order to ensure the health of ice cream consumers and increase the service life of commercial ice cream machine machine parts, you must clean the refrigeration cylinder once a day.


(1) Press the cleaning button to discharge all the slurry in the tank, and press the stop button.


(2) Add appropriate amount of disinfectant with warm water and pour it into the bucket, the same amount of water in the two buckets.


(3) Press the cleaning button and stir for about 1-2 minutes to drain the cleaning solution.


(4) Wash with water for 2-3 times and stop.


(5) Turn off the power and disassemble and wash all parts.


a. Unscrew the four screws on the side of the discharge valve and remove the discharge valve assembly.


b. Pull out the pin, handle, stem and seal ring from the discharge valve in sequence.


c. Pull out the agitator from the refrigeration cylinder and remove the sealing ring.


d. Clean all the removed parts, and replace them in time if they are damaged.


e. Install the parts according to the reverse steps of disassembly.




Body cleaning


Consumers need beautiful, clean and hygienic machines. Please keep the appearance of the fuselage clean at any time. You can wipe the fuselage with a warm towel to remove stains. Do not rinse with water to avoid electrical failure.




Cleaning the condenser


Working for a period of time, the condenser will stick to dust and affect heat dissipation, and the cooling effect is poor. The specific cleaning time can vary from three months to six months depending on the operating environment. Turn off the power before cleaning, be sure not to damage the condenser fins, use a soft brush And hair dryer can be cleaned.




Transmission adjustment


After the machine is used for a long time, the driving belt of the mixing system may be elongated and needs to be adjusted. The phenomenon is that the belt slips. The machine suddenly stops after a while. Some soft ice cream machine digital tubes will display the word "NL" and beep at the same time. The device emits a regular intermittent sound for a long time. At this time, disconnect the power supply, remove the left side panel of the machine, and use a wrench to adjust the screws fixed under the motor. This situation is not a malfunction of the machine. Before adjusting the belt, the power must be stopped and the belt adjusted. After proper tightening, the machine will return to normal.


CALL
PRODUCT
VIDEO
SERVICE QQ